Application injection

How to properly apply the injection peptides

1) Important health and safety rules:

• Before each application of injection peptides first wash your hands thoroughly.
• Always use a new and unwrapped 100% of the syringes, which were undamaged sterile packaging!
• Never touch the needle with your hands or other objects (if unintentionally such contact occurs, discard the syringe and use a new one)!
• Never use a syringe more than once (multiple use of one syringe needles increases the possibility of contamination with bacteria, and the needle is simultaneously each application blunts and damages)!
• Before the needle penetrates the rubber vial closure and skin at the site of first thoroughly clean the spirit disinfectant swabs!

2) Types of injection and possible sites:

• Subcutaneous – subcutaneous injection (administration into fat): The application of most peptides suffices called subcutaneous = subcutaneous administration (administration into the fat / space between the top layer of the skin and muscles), and it is not necessary intramuscular (Exceptions are growth factors, which are listed in intramuscular injection). Most often inject subcutaneous injection into the abdomen (abdominal fat front on his stomach in a radius of 8 cm around the navel). Properly implemented subcutaneous injection in the abdominal fat is painless, simple and inexpensive (the place is easily accessible, visible and accessible hands). Or it can be subcutaneous injection pricks into fat ass, this application is also essentially painless place but now it is difficult to reach.
• Intramuscular injection (administration into a muscle): Intramuscular injection is more suitable for growth factors IGF-1, MGF and myostatin inhibitors because they are significantly more effective and efficient when the insertion directly into a muscle, because in them and the resultant effect. The most common site is the side page front thigh muscles – quadriceps, the application unlike subcutaneous injection may already mildly hurt or be uncomfortable (depending on how sensitive point hit, but because it still is a really tiny needles, and there is pain, perhaps only a slight – low). The second most common site of intramuscular injection, the central portion deltoid on the side arm. This site is somewhat less accessible than the thigh, in most cases it is almost painless injection also similar to subcutaneous injection.

Warning: For intramuscular injection, it is important to be concerned muscles relaxed and completely at peace, enabled. Otherwise, the application will unnecessarily hurt more.

3) Application Procedure injecting peptides – step by step guide:

Preparing the injection:

Ampoule containing peptides after removal from the refrigerator put on a clean table. Rubber plug on top of the first vial and wipe clean with an alcohol swab disinfectant, in order to remove any bacteria and debris from the surface and unable to reach the needle.

Unpack the new unused syringe and remove the plastic caps on both ends. During the entire handling the syringe, make sure that the needle does not come into contact with your hands or other unwanted objects.

Insert the needle through the rubber stopper into the top ampoule, consult the contrary “upside” of 180 °. Visually check that the needle end is not in the air bubble in the neck of the vial (If yes, please vial back again and again to the opposite position). Slowly draw the necessary number of pieces of peptide solution that corresponds to the desired dose. Turn the vial back to its normal position and pull out the needle and syringe. Injection is ready for application.

Injecting:

First, clean the skin at the site of injection with an alcohol disinfectant swabs (circular motions within a radius of at least 3 cm from the injection site).

• Subcutaneous – subcutaneous injection (used for all peptides and compounds in addition to IGF-1, MGF, ACE-031 and follistatin): The recommended site for needle insertion is an area on the belly of approximately 8 cm in radius around the navel. Hold the needle close to the injection site and under approx. 45 ° angle it quick and resolute movement push the entire length beneath the skin. Smoothly push the syringe into the body. Wait at least 5 seconds, and a needle with a quick motion pull out. Instead, after insertion, wipe with an alcohol swab.

• 
  Intramuscular injection intramuscular injection is preferable to subcutaneous only growth factors often focused on volume and increase muscle: IGF-1, MGF, ACE-031 and Follistatin-344. The recommended site for needle insertion is the middle part of the deltoid muscle on the side of the shoulder or side of the front thigh muscles – quadriceps. Hold the needle close to the injection site and under approx. 90 ° angle perpendicular to muscle her first rapid and vigorous movement push under the skin, and then proceed slower continuous motion until the needle into the body fit its entire length (the needle should get up in the muscle). Smoothly push the contents of the syringe. Needle with a quick motion pull out. Instead, after insertion, wipe with an alcohol swab.

Note: After use, be sure to put the syringe needle back the plastic cover before it cast away into the drain (the needle accidentally someone abrading) and make sure that the syringe was not blown away from children! Never use a syringe more than once (multiple use of one syringe needles increases the possibility of contamination with bacteria, and the needle is simultaneously each application blunts and damages)!

Our type: Secret jab injection so that the pain-free and needle smelled least is speed needle penetration (as quickly penetrate a needle through the top, the sensitive layer of the skin): Receptors for feeling pain located in the largest numbers in the upper layers of the skin. In the lower layers of muscle and there is already much less. If you prick the skin quickly, not have time to react and you realize pain, or it usually is felt. However, if you pierce the skin on the contrary, slowly, surely it will feel and such applications will certainly be more painful.

4) Preparation of (diluting) the optimal dosage and use of peptides :.

To all injectable peptides and substances that have purchased from us we add or send to your email information from which you will learn:

• how to properly and in what proportion diluted with water for injection solution
• how much / individual dose when using the research ideal to use when and how often, with regard to your desired goals you want to achieve and individual physical characteristics (age, weight, shape, etc.).
• guidelines and recommendations in the scientific use of specific peptides and compounds

We will advise you

In the event that you can not decide which chemicals and peptides, you should buy and which will be best for you to achieve the desired goals, we will be very pleased to advise you. We have rich and years of practical experience with peptides, just if you write us!